Whenever a vehicle battery has to be disconnected, switch off all equipment, interior lights etc, close the doors leaving the driverâs window open. Switch off the ignition and remove the key and any diagnostic equipment. Wait a full 3 minutes before disconnecting the battery. The BSi must be allowed to go to SLEEP i.e. into "active economy mode".
Tonypandy. Jul 23, 2011. #2. adamwindsor said: Hi all have not long brought this van itâs a scudo 51 reg 53k 2.0 jtd it has been serviced about 1000 miles a go and it was fine drives well plenty of power turbo working fine but this morning went to go the skip then the engine management light came on it drives fine as far as I know took it13. Oct 31, 2017. #1. Hi guys, just fitted new Crosland fuel filter as part of oil and filter service for my 2007 1.9 jtd 16valve multijet 150. For some reason, after priming filter with 5/6 key turns to mar position, I now have `check fuel filter` warning on dash. Anyone had this and whats the solution ?
I was driving home this evening when about 3 minutes into the journey the engine light came on and screen read "check engine". The car drove perfectly fine and got home (25 miles mainly on dual carriageway and motorway) without a problem however I noticed that the fan was on what sounded like full power when I stopped to make a drop off half way. How to reset the dual zone climate of the Fiat Bravo. If the two-zone electronic climate control system is installed on your Fiat Bravo and it happens that it does not respond correctly to the commands, or that it does not respect the temperature differences set by the driver and the passenger, it may be due to the fact that it is not able to control the opening vanes perfectly. and closure of Posted on 30/11/2021 12:49 by Smithee. I have a 2017 Autotrail 15k miles, fitted with a 2.3 Ducato diesel engine. I get the "engine check" warning light coming on. The garage in my area has checked it out with their laptop and it shows lambda sensor problem. They have replaced the sensor twice with two new ones but the light still comes on. Step 3: Disconnect the fuse and let the system sit that way for a few minutes. Step 4: Proceed to turn off the ignition before plugging in the fuse. Step 5: Turn on the ignition to start the car and let it idle for a while. You can watch the process of resetting the check engine light by pulling out the ECU fuse here. GQnPKiE.